請教各位，為什么我的MX SHEET的Access Data里面沒有Value一欄，使用起來“Monitor”和“Logging”功能正常，“Write”卻始終無法實現(xiàn)，錯誤記錄為：
“The wrong value is inputted into the cell area.
Write process of the corresponding cell area was not performed.

The corrective action is as follows:
Input the data in the entire write cell area.
Set either 0/1 data in the bit type cell.
Confirming whether the string data is not set in the cells other than string type.
Magnification is set up so that operation result may not overflow.”
請用過的大大指教。
說明書上圖片

我實際運行后截圖

光有人看沒人回啊？

When "Data Type" has been set to "Bit" or "Character string", the
"Zoom" setting is not possible.