運動控制CPU軟件 MT-DEVELOPER / SW6RNC-GSVE安裝后出現沒有找到SSCPDR6.dll 不能啟動，我已經重裝系統了，還是不行。有沒有人知道系統不兼容處理。

1) SNETP is not installed. Even if communication with the CPU is not made actually, SNETP must be installed. Refer to section 3.1 "Installation" to install the SW6RN-SNETP (Ver. 00B or later. If communication is made only with the Q172/Q173CPU, install SW6RN-SNETP.
• A list of applications for communication with the CPU is displayed. The following applications cause the phenomenon described to the left. (Applications other than those listed below operate without SNETP.)
GSV[ ][ ]P : Monitor, communication, program editor, install, mechanical system editor, test, backup, servo data setting (for writing to servo amplifier)
SW6RN-DOSCP: Digital oscilloscope
2) SNETP has been installed but is incompatible with the package given on the left. (SW6RN-SNETP (Ver. 00B or later) has been installed.) Refer to "3.7 Updating Instructions and Procedures" and update one set of SW6RNC-GSVE.
3) The PATH specified as the long name has been described in AUTOEXEC.BAT.
*: Long name: Folder name of 9 or more characters
Describe the SNETP PATH before the PATH specified as the long name, and always add "%PATH%" before the part where the long name has been specified. It is not required if it has already been described.
(Example)
• Before change SET PATH="C:\ProgramFiles\ABC;" (*1) SET PATH=%PATH%;C:\PROGRA~1\Sw6Sne~1; (*2)
↓
• After change SET PATH=%PATH%;"C:\PROGRA~1\Sw6Sne~1;"SET PATH=%PATH%;"C:\ProgramFiles\ABC;"
*: Always described the (wiggly line) part.
(*1): Long name PATH
(*2): SNETP PATH

謝謝！沒有太懂，安裝后SYSTEM SETTING -GSV22P -MT DEVELOPER 正常開啟，SERVO DATASETTING正常開啟 PROGRAM EDITOR  ，MONITOR，不能使用 出現不能啟動

請大家指教，問題在SW6Snetpe,通訊程式

SW6RN-SNETP 安裝沒有?

樓主是不是Sw6Servome\DigitalOsiloScope.exe無法運行？
如果是就請將附件中的文件解壓后存放到Sw6Servome文件夾中

學習了，謝謝，看看。

學習了謝謝！！！！

斑竹太好了...

學習了謝謝！！！！

什么問題

學習了謝謝！！！！